![]() ![]() Start spraying carefully each side until they are all covered up in paint. Take the wire basket outside or on a safe-to-paint environment, and give it a quick clean with a paper towel. Depending on how big your wire basket is, one can of spray should be enough. Pick a can of spray on your color of choice and a protective layer spray. Also, if there are sharp edges that didn’t cut close enough, you can bend it back and forth as near the seam line as possible, and they should come off pretty easily.Įven though most people like the plain steel look of the wire, you may choose to décor the basket by painting it your favorite color. Repeat the same counting process to the other corner and you will end up cutting your wire into a shape of a cross (4 flaps) and each end or flap will end up being a side of your basket.įor this process, I suggest you wearing work gloves as you cut through the wire, so the wire edges don’t cut your hands. ![]() I cut mine by counting fourteen squares in from each corner and then counting another fourteen squares down. If you are having a hard time deciding how big your basket should be, you can get a basket you already use and put it on top of the wire rod as a reference. As I said earlier, you can put pressure on one side of the wire roll to help it straighten out easily.ĭecide how wide and deep you want your basket to be and cut the wire according to these dimensions. Roll out your hardware cloth and flatten it as much as you can. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |